In the Wingraf manual from p3-142 to p3-143, it supports
Design stress of material, such as SIGD Compression stress, SIGZ Tensile stress, STAU Shear stress, SIGV v.Mieses stress, SPC Principal compression stress, SPT Principal tensile stress
and
Design stress of stress point (SPT), such as
SDPT Compression stress, SZPT Tensile stress, STPT Shear stress, SVPT v.Mieses stress, SPCP Principal compression stress, SPTP Principal tensile stress
I made a simple cantilever beam in glabal X direction, and apply unit point force at its free end in the PG direction. I have several questions about these stresses and how to plot them on the model
- What’s the difference between Design stress of material and Design stress of stress point (SPT)?
- I run the AQB, and wingraf with stress output, the GUI does show stress
but there is no stress plot in the wingraf, it show several warnings about stress output
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SIGD not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SIGZ not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE STAU not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SIGV not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SDPT not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SZPT not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE STPT not valid :
Kind of system not valid or undefined element type
+++++ warning no. 802 in program gr3_e_stab
BEAM TYPE SVPT not valid :
Kind of system not valid or undefined element type
Teddy DAT file is attached.
Abq.dat (2.1 KB)